Tally Genicom T5023+ - Manual (Page 375)

Appendix Error messages
T5023/5023+ - Programming Guide 365
Error Cause / Possible action Service information:
No. / Meaning
POWERSUPPLY
HOT The power supply is too hot
Rests between printing of the
lines
TRANSP
ERROR
(TRANSPORT ER-
ROR)
Document feed error
Control motor blocked (platen,
guidance hook, MSR pressure,
MICR pressure)
Control motor not plugged,
electronic defect
00
Motor control
01
Motor transport
FEEDER
ERROR Feeder hardware error
MICR
ERROR Magnetic ink character reader
MSR WRONG
ORDER Magnetic stripe reader 01
Wrong sequence
02
Wrong parameter
03
Wrong character
04
Wrong character length