Tally Genicom T5023+ - Manual (Page 357)

Appendix IBM Emulations
T5023/5023+ - Programming Guide 347
Variable initialisation parameters 4722 emulation:
Fixed initialisation parameters 4722 emulation:
IBM4722 Switch - Electronic Board T5023/5023+ Setting
IBM4722 Switch 1 Audible Alarm Not supported
IBM4722 Switch 2 Zero Slash Not supported
IBM4722 Switch 3 Automatic Line Feed Emulation menu LF (LF = LF)
IBM4722 Switch 4 Reserved
IBM4722 Switch 5 Character Set Character set 2
IBM4722 Switch 6 Automatic CR Emulation menu CR (CR = CR)
IBM4722 Switch 7 Reserved Character set 2
IBM4722 Switch interface card
SW 1..3 Baud rate Interface menu
9600,4800,2400,1200 (9600)
SW 7 Reserved Interface menu Protocol (DTR)
Emulation menu Multi Part (OFF)
Emulation menu Typeface DQ,
Roman, Sans Serif (DQ-Sans Serif)
It is normally not necessary to set the operating panel parameters in the
4722 emulation.
Parameters T5023/5023+ parameter
in the 4722 emulation
Top of form position Line 2 (6 LPI)
Char. density 10 CPI
Char. width Normal
Country USA
Left edge Column 1 (10 CPI)
Ref. edge Left
i