Tally Genicom T5023+ - Manual (Page 161)

Character set commands Switching on italic print
T5023/5023+ - Programming Guide 151
Switching on/off the character set defined by the user
Function:
Using ESC % (n) the character set defined by the user is switched on. Charac-
ters defined by the user will only be printed if the currently selected print quality
(draft or LQ) and the current print mode (proportional or superscript/ subscript)
correspond to the character definition.
n = 0: user-defined character set off
n = 1: user-defined character set on
ESC
27
1B
%
37
25
(n)
n
n
ASCII character
Decimal
Hexadecimal
The sections “Character set selection” and “Character definition” con-
tain further notes and program examples for the command ESC % (n).
i