Tally Genicom T5023+ - Manual (Page 303)

Control of Asian Character Sets
T5023/5023+ - Programming Guide 293
Example:
Switch-over from 1-byte characters to 2-byte characters and vice versa:
ESC [1$q Switch to 2-byte mode, character set GB2312-80
Attributes
The attributes ’bold’, ’elongated print’, ’condensed print’ and ’underscore’ can be
applied to the Chinese characters. The subscript and superscript attributes are
not possible and produce undefined print results.
The text layout functions ’block print’, ’centering’ and ’right-justified’ cannot be
used in conjunction with 2-byte characters.
Character pitch (HMI)
Epson ANSI emulation
The character pitch currently set (10, 12 or 15 CPI) will be used when character
codes are transferred from the 1-byte character range. The character pitch will
be doubled accordingly for Chinese characters (6, 6 or 7.5 CPI). When the
attributes ’elongated print’ or ’condensed print’ are used, the character pitch is
multiplied with the factor of 0.5 or 2.
The character set enabled by the operating panel selection will be active after
power-on. This presetting can be superseded by the control command shown in
the following table.
/h B1 A2 31 32 33 B1 B2 B2 31 0D
Character 1 1-byte
character from
the EPSON
character set
Character 2 Because the
character B2/31
does not exist in
GB2312, the
character B2 is
ignored. The
character 31 is
recognized as a
character from the
EPSON character
set.
Initialize
printout