Tally Genicom T5023+ - Manual (Page 277)

Application examples Passbook processing with MSR
T5023/5023+ - Programming Guide 267
Program steps (annotated)
1. Setting MSR parameters
Command: CSI n1; n2; n3; n4; n5 ! r
Parameters: n1 = 0 (no write repetitions = default value)
n2 = 0 (no read repetitions = default value)
n3 = 0 (write/read format = DIN)
n4 = 99 (vertical distance from leading edge =
99/ 180 inch = 14 mm)
n5 = 1 (bottom leading edge)
Remarks: This parameter combination corresponds to
the default setting of the document printer
for MSR processing. Therefore, this program
step could be omitted, if previously another
parameter setting was not selected.
2. Specifying the horizontal leading edge (logical)
Command: CSI n % t
Parameter: n = 1 (form guidance on right)
Remarks: This program step is only relevant if ’left
leading edge’ mode is set as default.
3. Reading the magnetic stripe (MSR data)
Command: CSI " r
Remarks: If the passbook is not inserted and drawn in,
this command initiates a document request
(READY
LED on the operating panel flashes).