Tally Genicom T5023+ - Manual (Page 245)

Additional commands (Printer) Electronic Journal Functions
T5023/5023+ - Programming Guide 235
Electronic Journal Functions
Change between Document and Journal Printing
Parameter:
The parameter ’Journal memory’ is used to redirect all following print characters
to a resident memory. All control sequences are ignored, except for line feeds.
This command initializes the printout of all characters still located in the internal
print buffer.
Command sequences which are written into the journal memory have no influ-
ence to the printout off the document station:
This function is available only in the device variant with ’memory extension’. The
selection Memory Extension -> EL-Journal must be enabled from the Service
menu. If the selection is not enabled, the command will be ignored
.
In this mode, the responses are extended.
CSI
ESC
27
1B
[
91
5B
n
n
n
n
!
!
33
21
q
q
113
98
Name
ASCII character
Decimal
Hexadecimal
n = 0 Document print (Default)
n = 1 Electronic journal memory
When the electronic journal memory is enabled, only the net data (prin-
table characters) is stored. Any attributes, tabs, character set com-
mands are filtered from the data stream. Graphic data is not supported.
i