Tally Genicom T5023+ - Manual (Page 163)

Character set commands Switching on italic print
T5023/5023+ - Programming Guide 153
Switching off extended character set
Function:
The command ESC 7 influences the complete upper character table. The effect
of the command depends on the character set activated using ESC t (n):
– The upper character table contains characters defined by the user. ESC 7
cancels the effect of the command ESC 6. The upper and lower control code
tables are identical.
– The upper character table contains graphics characters. After ESC 7 is en-
tered, the upper and lower control code tables are identical.
– The upper character table contains italic characters. In this case, the com-
mand ESC 7 is ignored.
ESC
27
1B
7
55
37
ASCII character
Decimal
Hexadecimal
The introductory section “Character set selection” in this chapter con-
tains further notes on the command ESC 7.
i