Tally Genicom T5023+ - Manual (Page 180)

Syntax of the graphics commands Graphics commands
170 T5023/5023+ - Programming Guide
Switching on the ’double density and double rate’ graphics
mode
Function:
The 8- dot graphics mode “double density and double rate” is switched on with
ESC Y (n) (m).
The parameters n and m determine the number of dot columns to be printed:
Number of dot columns = m * 256 + n
One data byte must be specified per dot column.
ESC
27
1B
Y
89
59
(n)
n
n
(m)
m
m
Data...
Data...
Data... ASCII character
Decimal
Hexadecimal
– The section “Mode of operation of the graphics commands” con-
tains further notes on the command ESC Y (n) (m).
– Using ESC ?, any graphics mode of the document printer can be
assigned to the command ESC Y.
i