Tally Genicom T5023+ - Manual (Page 302)

Control of Asian Character Sets
292 T5023/5023+ - Programming Guide
The following intending formats are currently implemented:
When a 2-byte character generator is available, this character generator is
automatically enabled after power-on.
After a default font number has been specified, the relevant character is set.
If a default font number is not specified in the character generator, the character
set selected from the operating panel menu will be set.
Control sequences under 20h and/or ESC sequences will be executed where
possible.
When character codes from the 1-byte range of characters are transferred, the
LQ font currently set and the corresponding character set will be printed.
GB 2312-80 VR China For character assignment see Appendix,
section „Chinese Characters in the Pass-
book / Document Printer“.
GB 5007 VR China For character assignment see Appendix,
section „Chinese Characters in the Pass-
book / Document Printer“.
GB 5199 VR China For character assignment see Appendix,
section „Chinese Characters in the Pass-
book / Document Printer“.
BIG5 Traditional
Chinese
(Hongkong and
Taiwan) For character assignment see Appendix,
section „Chinese Characters in the Pass-
book / Document Printer“.