Tally Genicom T5023+ - Manual (Page 179)

Graphics commands Syntax of the graphics commands
T5023/5023+ - Programming Guide 169
Switching on the ’double density’ graphics mode
Function:
The 8-dot graphics mode ’double density’ is switched on with ESC L (n) (m).
The parameters n and m determine the number of dot columns to be printed:
Number of dot columns = m * 256 + n
One data byte must be specified per dot column.
ESC
27
1B
L
76
4C
(n)
n
n
(m)
m
m
Data...
Data...
Data... ASCII character
Decimal
Hexadecimal
– The section “Mode of operation of the graphics commands” con-
tains further notes on the command ESC L (n) (m).
– Using ESC ?, any graphics mode of the document printer can be
assigned to the command ESC L.
i