Tally Genicom T5023+ - Manual (Page 221)

Additional commands (Printer) Controlling the MSR / MICR functions
T5023/5023+ - Programming Guide 211
– Table for recording formats
Depending on the recording formats, the user must transfer the following va-
lues via CSI ... ! r, in order to be able to process the following recording mo-
des:
– Default values:
If no parameters are set, the respective MSR transactions are carried out on
the basis of the following default values:
– Incorrect parameters:
If incorrect parameters are used, these are reset to their default values with
the exception of n3. The use of an incorrect n3 parameter (format) leads to
an error message of the printer.
Format n3 n4 n5
DIN 0 14 mm (99/180") 1
IBM 1 1 11 mm (78/180") 1
IBM 2 2 11 mm (78/180") 1
105 characters 5 14 mm (99/180") 1
ISO 7811 6 14 mm (99/180") 1
n1 = 0 (unsuccessful writing attempts are not repeated)
n2 = 0 (unsuccessful reading attempts are not repeated)
n3 = 0 (writing of the magnetic stripe in the DIN format, reading
of the magnetic stripe in the DIN/ IBM format)
n4 = 99/180 inch vertical distance from the leading edge
n5 = 1 (bottom leading edge).