Tally Genicom T5023+ - Manual (Page 213)

Additional commands (Printer) Basic commands for document processing
T5023/5023+ - Programming Guide 203
n = 0 : manual error handling
After an error the operator must clear the error via the operating panel
of the printer and put the printer into ONLINE status (also
see the
operating manual)
n = 1 : automatic error handling
After an error the following actions are executed by the printing unit:
– Locking the printer interface for further data;
– Response ’Global printer status’ in the coding CSI n ! z with n=2
(ERROR);
– Response ’Special printer message’ in the coding CSI n; m " z
with n=2 (NO PAPER);
– Paper ejection, deletion of all print buffers, setting of default para-
meters;
– Response ’Global printer status’ in the coding CSI n ! z with n=0
(ONLINE);
– Release of the interface for the transfer of new data.
The operator no longer needs to clear the error status on the printing
unit. However, after a short pause (ejection of the document) the
printing unit is in the ONLINE status again for the system driver and
can thus be addressed.
The default value n=0 (manual error handling) is valid after switching
on the printer. Other control commands, initializations or error
statuses do not change this parameter.
i