Remote monitoring options, To install the remote monitor’s cable, Figure 3-23 remote monitor port locations – Xantrex Technology SW Plus 4024 User Manual
Page 123: Remote monitoring options –41, Figure 3-23, Remote monitor port locations –41
Optional Equipment
976-0043-01-02
3–41
Remote Monitoring Options
The
Sine Wave Plus
can be controlled remotely by connecting an
additional ICM or by using an ICA connected to a personal computer. The
ICM operates identically to the ICM display on the front of the
Sine Wave
Plus
.
See the ICM Installation Guide for specific installation instructions for
installing the remote ICM.
See the ICA Owner’s Guide for specific installation instructions for
installing the ICA.
To install the remote monitor’s cable:
◆ Connect the appropriate end of the cable from the remote monitor of
choice to the “REMOTE” port on the AC end of the inverter.
Figure 3-23 Remote Monitor Port Locations
Inverter Control Module (ICM)
(for distances of 25 or 50 feet)
Inverter Communications Adapter
(ICA) (for distances up to 50 feet)
For distances greater than 50
feet, a modem must be used.
The ICM and the ICA use the
same communications port to
connect to the inverter. You
cannot use both methods at the
same time for monitoring the
system.
AC End of Inverter