How to use the epo port for an epo switch, Figure g-2 – Xantrex Technology SW Plus 4024 User Manual
Page 326
Emergency Power Off Switches
G–4
976-0043-01-02
the building at a readily accessible location. The shunt trip switch,
when installed should be between six (6) feet and six feet seven
inches (6'7") above finish grade. A sign constructed of permanent
materials with no less than 1½" high letters designating "Shunt Trip -
Main Disconnect" shall be located on the exterior of the building or
structure, and approximately one foot (1') above and one foot (1') to
one side of the shunt trip mechanism. Service disconnecting means
shall not be installed in bathrooms.
How to use the EPO Port for an EPO Switch
The following diagram shows how to modify a 6-conductor cable to
connect the
Sine Wave Plus
for an Emergency Power Off Switch.
Figure G-2 Modifying a 6-conductor Cable to connect to the EPO Port