Xantrex Technology SW Plus 4024 - Manual (Page 85)

Pre-Installation
976-0043-01-02 3–3
Hardware / Materials Required
The following materials may be required for completing this installation.
❐ 4' x 8' sheet of ¾" plywood for mounting
❐ 2 x 4 boards for mounting
❐ #10 and/or #12 wood screws (or ½" x 1¼" lag bolts)
❐ Conduits and appropriate fittings for wire runs (e.g., wire nuts)
❐ Electrical wire of appropriate size and length
❐ Battery cable lugs (depending on types of battery cables used)
❐ Breaker panels
❐ Ground busses, bars, bonding blocks, and/or rods
Optional System Accessories
The following optional system accessories can be used in the installation
of the
Sine Wave Plus . These accessories are available from any
authorized Xantrex dealer. Consult with your local system designer to
determine what optional equipment will be needed for your specific
installation.
Conduit boxes:
❐ ACCB with input/output/bypass breakers
❐ DCCB
Battery cables:
❐ BC1.5 (Single) Battery Interconnects
❐ BC2/0 AWG (Pair), available in 5 and 10 foot lengths
❐ BC4/0 AWG (Pair), available in 5, 10, and 15 foot lengths
DC disconnects and fuses:
❐ DC175 (175 Amp DC Disconnect with Bonding Bar)
❐ DC250 (250 Amp DC Disconnect with Bonding Bar)
❐ TFB 200 (200 Amp Class-T Fuse)
❐ TFB 300 (300 Amp Class-T Fuse)
❐ TFB 400 (400 Amp Class-T Fuse)
❐ PV Ground Fault Projection (PVGFP1, PVGFP2, PVGFP3,
PVGFP4)