Activeforever Plextalk PTR2 Digital DAISY Player and Recorder - Manual (Page 117)

118
place at this time. The red LED in the Record key will flash on and off
constantly.
During recording, audio input is being recorded to disc or CF card. You
can adjust the recording level but cannot adjust the recording mode or
sound quality setting. The red LED in the Record key is on constantly.
The basic steps for recording with PLEXTALK are as follows:
• Insert the CD or CF card you wish to record onto.
• Select the input source you wish to use and connect the
appropriate hardware.
• Select the recording mode and sound quality (this is described
later. It can be done before or after going into recording stand by).
• Press the Record key once to go into recording stand by.
• Set the recording level.
• Press the Record key again to start recording.
• Press the Record key again to pause recording at any time.
• Press the Record key to start recording again.
• Press the Play/Stop key to stop recording.
NOTE: You can pause recording as often as you need to. Every second
time you press the Record key, PLEXTALK will pause recording. Every
other time you press the Record key, PLEXTALK will start recording again.
NOTE: In Normal mode, when you start recording, a new section or track
will be created automatically. The audio will be appended to the end of
any existing audio and you do not need to navigate to the end before
recording.
16.11. Turning the recording monitor on and off.
PLEXTALK enables you to monitor any recording as it is being made, so
you can gauge how the recording will sound in the end. This section
details how to turn on and off the recording monitor.
You can turn the recording monitor on or off in recording stand by,
recording pause or during recording. This is done as follows: