Activeforever Plextalk PTR2 Digital DAISY Player and Recorder - Manual (Page 36)

37
• Place PLEXTALK on a flat surface in front of you in the normal
operating position described above.
• Locate the AC adaptor and mains power cable that was supplied
with your PLEXTALK. The AC adaptor consists of a rectangular
transformer block with a fitted cable. At the end of the cable is a
small round connector. The mains cable has an oval shaped, 2-pin,
female connector at one end and a mains plug at the other end.
• CAUTION: Before proceeding any further, you should ensure that
you do have the correct type of mains cable for your country's
mains supply. If you don't have the correct cable, you should
contact your local PLEXTALK agent for a replacement.
• Plug the small round connector, on the cable that is connected to
the transformer block, into the round socket at the back of your
PLEXTALK.
• Now connect the oval shaped connector, on the mains cable, to
the socket on the transformer block.
• Plug the other end of the mains cable into a suitable mains outlet
and ensure that all plugs are firmly fitted.
• You can now turn on the mains power switch. With the power
turned on, the mains indicator LED will light up. If the internal
battery is not fully charged, the light will be red. This will change
to green when it reaches full charge.
NOTE: The mains indicator LED will light up regardless of whether
PLEXTALK itself is on or off.
6.6. Turning PLEXTALK on and off.
To turn on the power, do the following:
• locate the Power On/Off switch, which is near the back of the right
side of PLEXTALK.