Activeforever Plextalk PTR2 Digital DAISY Player and Recorder - Manual (Page 37)

38
• Push it towards the rear of PLEXTALK. You will hear musical tones
that indicate that the unit is powering up.
• Release the switch and it should return to a centre position.
• After a short pause, PLEXTALK will either say "No disc", "Disc" or
"Card" according to the type of media in PLEXTALK when it is
switched on. "No disc" means that there is no disc or card in the
unit at that time. "Disc" means that the CD drive is being accessed
and "Card" means that the card is being accessed.
• Depending on the type of media in PLEXTALK, a variety of audio
outputs may be heard at this time. The details will be discussed
later.
• PLEXTALK is now ready for use.
NOTE: Assuming that no media has been removed since its last use, The
PTR2 will always attempt to access the disc or card that was in use when
the unit was shut down previously.
To turn off the power, do the following:
• Pull the Power On/Off switch towards the front of PLEXTALK and
release it. The switch will return to the middle position.
• The unit will beep and then announce that it is shutting down.
• Musical tones will indicate that the unit is busy and, after a short
while, a different musical sound indicates that PLEXTALK has
completed the shut down process.