Activeforever Plextalk PTR2 Digital DAISY Player and Recorder - Manual (Page 127)

128
• When you have made this last selection, PLEXTALK will confirm
that the settings have been set. It will then exit the menu system
and return you to the status you started the process from.
NOTE: As for the preset recording modes, selecting the Custom recording
mode can be carried out either before or after going into recording stand
by.
NOTE: The Custom mode will remain the default recording mode until
you change it again.
17.4. Checking the recording level during recording.
In DAISY format recordings, it is possible to check the recording level at
any time by using the level monitor. The default setting is for the level
monitor to be automatically muted when recording starts. You can,
however, recall the level monitor at any time during recording in order to
adjust or check the recording level.
Whilst in recording pause or during recording, do the following:
• Press the Information key once and PLEXTALK will say "Level
monitor on" followed by "Low", "Good" or "High" to indicate a low,
good or high recording level.
• Make the relevant adjustments to the recording level.
• Press the Information key once more and PLEXTALK will say "Level
monitor off".
NOTE: Within the recording settings, you must have the guide speech set
to "Guidance on" in order to hear the level monitor during recording.
NOTE: If you wish to use this feature and you are recording using the built
in microphone or an external microphone, it is recommended that you
use headphones during recording to avoid the monitor being picked up in
the recording.
17.5. Getting recording information.
In any of the 3 recording states, you can get information about the current
status of the recording as follows: