Activeforever Plextalk PTR2 Digital DAISY Player and Recorder - Manual (Page 147)

148
18.5. Getting recording information.
In any of the 3 recording states, you can get information about the current
status of the recording as follows:
In recording stand by, press and hold down the Information key.
PLEXTALK will say "Level monitor" followed by the available recording
time on the CD.
In recording pause mode, press and hold down the Information key .
PLEXTALK will say "Pause" followed by the amount of recorded time in the
current track and the available recording time left on the CD.
During recording, press and hold down the Information key. PLEXTALK
will say "Recording" followed by the amount of recorded time in the
current track and the available recording time left on the CD.
NOTE: If voice guidance during recording is set to "Guidance off", you will
not hear any of the above information during recording. You will still hear
the information in the recording stand by and recording pause states.
NOTE: In addition to the information given above, PLEXTALK will
announce the current battery status, the currently selected recording
mode and sound quality setting and the input source.
18.6. Editing tracks during recording.
Having already learned how to make a basic recording, you may now find
it useful to be able to add in tracks at specific times. PLEXTALK enables
you to set and cancel track information during recording. Tracks cannot
be cancelled after recording has been finished or after the CD has been
finalised.
This section tells you how to set and cancel tracks during the recording
process. Tracks can be set either when recording is paused or during
recording. Both methods are detailed below:
To set a track during recording, press the Heading key once. PLEXTALK
will say "Track XX". The new track is set immediately.