Xylem ProLab 4000 MULTIPARAMETER BENCHTOP METER - Manual (Page 173)

ProLab 4000 Recorder
173 ba75646e02 01/2010
12.6 Changing the displayed axis intercept
The standard settings for the displayed axis intercepts are defined in
the Recorder settings window for the time axis (register, Time), the
measured value axis (register, Measured value) and the temperature
axis (register, Temperature) (see page 169).
In the recorder window, you can change the displayed axis intercept
and move back to the standard display at any time.
Displaying the entire
time axis
The Total time axis function provides an overview of the entire process
since the recording of the measured value curve was started.
Displaying the time axis
with specified time
period
The Reset zoom function is used to reset the representation of the
recorder to the standard settings specified in the Recorder settings win-
dow.
The recorder then shows the specified minimum and maximum of the
measured value and temperature axis and the specified time period
(see page 169).
Displacing the axis
intercept
As described below, the axis intercepts of the recorder can be dis-
placed either in the direction of the time axis or in the direction of the
measured value/temperature axis. By his the displayed axis intercept is
displaced to the left/right or up/down but not scaled up.
This function is only available if the zoom function is not active.
13 Use [OK] to accept the new settings and close the dialog box,
Recorder settings.
The new settings are active.
or
Select another register to make further settings.
1 Open the Display / Total time axis menu.
The time axis from the start of the recording is displayed.
1 Open the Display / Reset zoom menu.
The representation of the recorder is reset to the standard set-
tings specified in the window, Recorder settings.