Extron Electronics MAV Plus Series User Guide User Manual
Page 119
Click
OK and proceed to step 4. The Extron Matrix Switchers Control Program
window (see
on the next page) appears, displaying the
current configuration of the attached matrix. Proceed to step 4.
•
If you selected
IP
[LAN]
, click
OK
and proceed to step 3.
•
If you selected
Emulate
, click
OK
and see
on page 127.
3.
If you selected IP [LAN] in step 2, the IP Connection window appears (see figure 63).
Figure 63.
Address and Password Entry
a.
Examine the Matrix IP Address field in the IP Connection dialog box. The field
displays the last Matrix IP address entered.
If the IP address is correct: Proceed to step 3b.
If the address is not correct: Either click in the Matrix IP Address field and
enter the IP address or click on the scroll down button ( ) and select from among
the recently used addresses. Proceed to step 3b.
NOTE: If the local system administrators have not changed the value, the
factory-specified default, 192.168.254.254, is the correct value for this field.
b.
If the switcher is password protected, click in the
Password
field and enter the
appropriate administrator or user password.
c.
Click
Connect
. The Extron Matrix Switchers Control Program window (see
on the next page) appears, displaying the current
configuration of the attached matrix. Proceed to step 4.
If you logged on using the administrator password, the program connects you to
the CrossPoint or MAV switcher with all of the administrator rights and privileges.
If you logged on using the user password, the program connects you to the
CrossPoint or MAV switcher with only user capabilities.
If an incorrect password was entered, the program beeps and returns to the
password entry display.
4.
Operate the switcher as desired.
•
To create a tie, drag an input box to one or more output boxes. To remove a tie,
drag the output box to its tied input box or to the trash can.
•
To set up audio in Follow mode (audio and video have the same tie configuration),
select the
Follow
box at the bottom of the window. To set up audio in breakaway
mode (audio and video have different tie configurations), deselect the
Follow
box.
•
To make the control program easier to use, assign a device icon to each input and
output. Click on a box that represents an input or output, and drag the desired icon
onto the box from the icon palette that appears.
•
For quick display of information on a specific input or output device, position the
cursor over that device in the control program window. The program opens a
window that details the connection to that device (see the inset box in
TIP: Click
File
>
Print Tie Map
to print a map of the current configuration.
CrossPoint and MAV Series Matrix Switchers • Matrix Software 113