Extron Electronics MAV Plus Series User Guide - Manual (Page 48)

Creating a Configuration
The current configuration can be changed using the front panel buttons. Change the current
configuration as follows:
1. Press the Esc button to clear any input button indicators, output button indicators, or
control button indicators that may be lit.
2. Select video, audio, or both for configuration by pressing the RGBHV (CrossPoint
switchers) or Video (MAV Plus switchers) button and Audio button as necessary.
3. Select the desired input and one or more output by pressing the input and output
buttons.
• For matrix sizes above 1616, input buttons light green.
• For matrix sizes up to 1616, input buttons light one of the following colors:
•
Amber: Video and audio ties
•
Green: Video only ties
•
Red: Audio only ties
• Output buttons light or blink one of the following colors:
•
Amber: Video and audio ties
•
Green: Video only ties
• Red: Audio only ties
• To indicate potential ties, output buttons blink the appropriate color when an
input is selected.
• To indicate current ties, output buttons light steadily the appropriate color when
an input is selected.
• To clear unwanted outputs, press and release the associated lit output buttons.
To indicate
potential unties, output buttons blink the appropriate color when an
output is deselected but not untied from the input.
4. Press and release the Enter button to accept the tie or to break an existing tie.
5. Repeat steps 1 through 4 to create or clear additional ties until the desired configuration
is complete.
NOTES:
• Only one video input and one audio input can be tied to an output.
• If a tie is made between an input and an output, and the selected output was
previously tied to another input, the older tie is broken in favor of the newer tie.
• If an input with no tie is selected, only the button for the selected input lights.
• When the RGBHV (CrossPoint switchers) or Video (MAV Plus switchers) button
and Audio button are lit, if an input with an audio tie but no video tie is selected,
the button for that input lights red (matrix sizes up to 1616) or green (matrix
sizes 3232 and above) and the output button lights the appropriate color
(amber, green, or red).
• As each input and output is selected, the associated output button blinks
the appropriate color to indicate a tentative tie. Buttons for outputs that were
already tied to the input light the appropriate color steadily. Outputs that are
already tied can be left on, along with new blinking selections, or toggled off by
pressing the associated output button.
• If you press the input button for an I/O grouped input and then try to select an
output in a different group, you cannot select the associated output button (the
action is ignored). The associated input button remains lit.
CrossPoint and MAV Series Matrix Switchers • Operation 42