Extron Electronics MAV Plus Series User Guide - Manual (Page 87)

Performing Soft Resets —
CrossPoint 450 Plus and MAV Plus 2412, 2424, 3216, and 3232 Matrix Sizes
The whole switcher reset function is identical to the front panel system reset (see
Performing a System Reset from the Front Panel on page 81) without requiring you
to power down the switcher. This function is also identical to the EZXXX} SIS command
defined on page 104. System reset clears all ties and presets, resets all audio gains to unity
gain (+0dB), and resets volume to 100% (0dB of attenuation).
NOTE: The whole switcher reset does not reset the Internet protocol (IP) settings or
replace user-installed firmware.
The absolute reset function is identical to EZQQQ} SIS command defined on page 104.
Absolute reset performs all of the whole switcher reset functions and clears the IP address
of the switcher to 192.168.254.254 and subnet mask to 255.255.0.0.
Perform soft resets as follows:
1. Use an Extron Tweeker or other small screwdriver to press and hold the Reset button
until the front panel I/I buttons (RGBHV [CrossPoint switchers] or Video [MAV Plus
switchers])) and Audio buttons blink once (reset whole switcher) or twice (absolute reset)
(see figure 56).
I / O
AUDIO
AC
T
LINK
ETHERNET
RESET RESET
RGBHV
I / O
AUDIO
AC
T
LINK
ETHERNET
RESET RESET
RGBHV
Front panel I/O buttons flash once.
Press and hold
the Reset button.
Reset whole switcher
Release, then immediately
press and release again.
Front panel I/O buttons flash twice.
Press and hold
the Reset button.
Absolute reset
Release, then immediately
press and release again.
5 seconds
10 seconds
Figure 56. Whole Switcher and Absolute Resets
2. Release the Reset button and then immediately press and release the Reset button
again. Nothing happens if the second momentary press does not occur within 1
second.
CrossPoint and MAV Series Matrix Switchers • Operation 81