Extron Electronics MAV Plus Series User Guide - Manual (Page 50)

The current configuration (see figure 33) is now input 5 video and audio are tied to output 3,
output 4, and output 8
Figure 33. Final Configuration, Example 1
Example 2: Add a video tie to a set of video and audio ties
In the following example, a new video tie is added to the current configuration. The example
shows the front panel indications that result from your actions.
NOTE: This example assumes that you have performed example 1 .
1. Clear all selections: Press and release the Esc button.
2. Select video only for the tie: Press and release the RGBHV (CrossPoint switchers)
or Video (MAV Plus switchers) button and the Audio button as necessary to light Video
only.
I / O
VIDEO AUDIO
Press the RGBHV or Video button to toggle on and off.
The button lights green when selected.
Press the Audio button to toggle on and off.
The button is unlit or background illuminated when deselected.
3. Select an input: Press and release the Input 5 button.
1 2 3 4 5 6 7 8 16
17 18 19 20 21 22 23 24 32
I
N
P
U
T
S
1 2 3 4 5 6 7 8 16
17 18 19 20 21 22 23 24 32
O
U
T
P
U
T
S
The Output 3, Output 4, and Output 8 buttons light green to
indicate the RGBHV or video ties created in example 1.
Press and release the Input 5 button.
The button lights green to indicate that video
outputs can be tied to or untied from this input.
4. Select the output: Press and release the Output 1 button.
CrossPoint and MAV Series Matrix Switchers • Operation 44