Extron Electronics MAV Plus Series User Guide - Manual (Page 49)

Example 1: Create a set of video and audio ties
In the following example, input 5 is tied to outputs 3, 4, and 8. The steps show the front
panel indications that result from your action.
1. Clear all selections: Press and release the Esc button.
C O N T R O L
PRESET ENTER ESC VIEW
Press the Esc button to clear all selections.
The button flashes once.
2. Select video and audio for the tie: If necessary, press and release the RGBHV
(CrossPoint switchers) or Video (MAV Plus switchers) button and the Audio button to
light both.
I / O
RGBHV AUDIO
Press the RGBHV or Video button to toggle on and off.
The button lights green when selected.
Press the Audio button to toggle on and off.
The button lights red when selected.
3. Select an input: Press and release the input 5 button.
1 2 3 4 5 6 7 8 15 16
17 18 19 20 21 22 23 24 31 32
I
N
P
U
T
S
Press and release the Input 5 button.
The button lights amber (matrix sizes up to 1616) or
green (matrix sizes 2412 through 3232).
4. Select the outputs: Press and release the output 3, output 4, and output 8 buttons.
C O N T R O L
PRESET ENTER ESC VIEW
1 2 3 4 5 6 7 8 15 16
17 18 19 20 21 22 23 24 31 32
O
U
T
P
U
T
S
Press and release the Output 3, Output 4, and Output 8 buttons.
The buttons blink amber to indicate that the selected RGBHV or video and audio
input will be tied to these outputs.
The Enter button blinks
green to indicate the need to
confirm the change.
NOTE: You can cancel the entire set of ties at this point by pressing and releasing
the Esc button. The Esc button flashes once.
5. Confirm the change: Press and release the Enter button.
ENTER
All input buttons and output buttons
return to unlit or background illumination.
Press the Enter button to
confirm the configuration
change.
The Enter button returns to
unlit or background
illumination.
CrossPoint and MAV Series Matrix Switchers • Operation 43