Extron Electronics MAV Plus Series User Guide - Manual (Page 152)

4. Click the RGB delay Drop box. A drop down scroll box appears (see figure 97).
Figure 97. RGB Delay Drop Box
5. Click the desired RGB delay.
Change the output volume level (audio models)
Change the volume level of an output as follows:
1. Click the Output drop box. A drop down scroll box appears (see figure 98).
Figure 98. Output Selection Drop Box
2. Click and drag the slider or click the scroll up button or scroll down button until the
desired output is visible.
3. Click the desired output.
4. Click the Volume Steps drop box. A drop down scroll box appears (see figure 99).
Figure 99. Volume Drop Box
5. Click the desired output volume step value.
NOTES:
• As an alternative to steps 4 and 5, or to listen to the audio as you make
adjustments, click on the up button or down button.
• Table 7 , on the next page, defines the value of each audio volume step.
CrossPoint and MAV Series Matrix Switchers • HTML Operation 146