Extron Electronics MAV Plus Series User Guide - Manual (Page 32)

RS-232/RS-422
h
Remote RS-232/RS-422 connector — Connect a host device, such as a
computer, touch panel control, or RS-232 capable PDA to the switcher via this 9-pin D
connector for serial RS-232/RS-422 control (see figure 23).
All Models
Matrix Sizes:
2412 through 3232
Matrix Sizes:
84 through 1616
MAV Plus 248 / 328 A
5
1
9
6
RS232/RS422
REMO
TE
RS-232 Function Pin Function
1
2
3
4
5
6
7
8
9 —
Tx
Rx
—
Gnd
—
—
—
—
Not used
Transmit data
Receive data
Not used
Ground
Not used
Not used
Not used
Not used —
Tx–
Rx–
—
Gnd
—
Rx+
Tx+
—
Not used
Transmit data (–)
Receive data (–)
Not used
Ground
Not used
Receive data (+)
Transmit data (+)
Not used
RS-422 Function RS-422
Tx+
Tx–
Rx+
Rx–
Gnd
—
—
—
—
Transmit data (+)
Transmit data (–)
Receive data (+)
Receive data (–)
Signal Ground
Not used
Not used
Not used
Not used
Figure 23. Remote RS-232/RS-422 Connector
See Programming Guide , beginning on page 89, for definitions of the SIS commands
(serial commands to control the switcher via this connector) and Matrix Software ,
beginning on page 110, for details on how to install and use the control software.
NOTE: The switcher can support either the RS-232 or RS-422 serial
communication protocol, and operate at 9600, 19200, 38400, or 115200 baud
rates. See
Selecting the rear panel RS-232/RS-422 port protocol and
baud rate on page 77, to configure the RS-232/RS-422 port from the front
panel.
If desired, connect an MKP 2000 or MKP 3000 remote control panel to the
RS-232/RS-422 connector on the switcher. See the MKP 2000 Remote Control Panel
User Guide or the MKP 3000 Remote Control Panel User Guide for details.
CrossPoint and MAV Series Matrix Switchers • Installation 26