Example 3: remove a tie from a set of ties – Extron Electronics MAV Plus Series User Guide User Manual
Page 51
C O N T R O L
PRESET
ENTER
ESC
VIEW
1
2
3
4
5
6
7
8 15 16
17 18 19 20 21 22 23 24 31 32
O
U
T
P
U
T
S
Press and release the Output 1 button.
The button blinks green to indicate that only the selected RGBHV
or video input will be tied to this output.
The Enter button blinks
green to indicate the need to
confirm the change.
5.
Confirm the change: Press and release the Enter button.
ENTER
All input buttons and output buttons
return to unlit or background illumination.
Press the Enter button to
confirm the configuration
change.
The Enter button returns to
unlit or background
illumination.
The current configuration (see figure 34) is now:
•
Video — Input 5 video is tied to output 1, output 3, output 4, and output 8.
•
Audio — Input 5 audio is tied to output 3, output 4, and output 8.
Figure 34.
Final Configuration, Example 2
Example 3: Remove a tie from a set of ties
In the following example, an existing tie is removed from the current configuration. The
example shows the front panel indications that result from your actions.
NOTE: This example assumes that you have performed
.
1.
Clear all selections: Press and release the Esc button.
2.
Select audio only for the tie: Press and release the RGBHV (CrossPoint switchers)
or Video (MAV Plus switchers) button and the Audio button as necessary to light Audio
only.
I / O
RGBHV AUDIO
Press the RGBHV or Video button to toggle on and off.
The button is unlit or background illuminated when deselected.
Press the Audio button to toggle on and off.
The button lights red when selected.
3.
Select an input: Press and release the input 5 button.
CrossPoint and MAV Series Matrix Switchers • Operation
45