Datamax-O'Neil Class Series Programmer’s Manual - Manual (Page 109)

Extended System-Level Command Functions
Class Series Programmer’s Manual 95
STX Kn NIC Reset
This command resets the NIC to factory defaults.
Syntax: <STX>Knx
Where: x - Specifies the action to take, where:
F = Returns the NIC to the factory default settings; and,
H = Reports settings to host (wireless, only).
Address
Default Values
Wired *
Default Values
WiFi
IP 192.168.010.002 192.168.010.001
Subnet
Mask
255.255.255.000 255.255.255.000
Gateway 000.000.000.000 000.000.000.000
* Prior to introduction of the WiFi, 192.0.0.192 was the IP default
value and the Subnet Mask was 0.0.0.0.
STX KO GPIO Output
This command configures the GPIO output channels of the Applicator Interface Card; see Appendix J
for details.
Syntax: <STX>KOffnsptd0pw0td1pw1<cr>
Where: ff - 2 character function name abbreviation (e.g., LC [Label
Complete], LM [Label Movement], etc).
n - Pin number, where 1 – 8 is the valid range.
s - Signal type, where: L = Level; P = Positive Pulse; and N =
Negative Pulse
p - Polarity, where: 0 = Active Low; and 1 = Active High
td0 - 3 character delay time from function condition “true” to
output signal.
pw0 - 3 character pulse width corresponding to the function
condition becoming “true”. (Ignored for level-type signals.)
td0
- 3 character delay time from function condition “false” to
output signal.
pw0 - 3 character pulse width corresponding to the function
condition becoming “false”. (Ignored for level-type signals.)