Datamax-O'Neil Class Series Programmer’s Manual - Manual (Page 29)

Class Series Programmer’s Manual 15
System-Level Command Functions
Introduction
The most commonly used commands are the System-Level Commands. These are used to load and store
graphics information, in addition to printer control. System-Level Commands are used to override default
parameter values (fixed and selectable) and may be used before or after Immediate Commands but cannot
be issued among Label Formatting Commands. System-Level Commands consist of:
1. Attention-Getter, 0x02 or 0x7E, see Control Codes.
2. Command Character
3. Parameters (if any).
STX A Set Time and Date
This command sets the time and date. The initial setting of the date will be stored in the printer’s
internal inch counter. This date can be verified by printing a Configuration Label.
Syntax:
<STX>AwmmddyyyyhhMMjjj
Where:
w 1 digit for day of week; 1 = Monday; 7 = Sunday
mm
2 digits for month
dd
2 digits for day
yyyy
4 digits for year
hh
2 digits for hour in 24 hour format
MM
2 digits for minutes
jjj 3 digits for Julian date (numerical day of the year) / constant; see notes below.
Sample: <STX>A1020319960855034
Printed response:
Mon. Feb 3, 1996, 8:55AM, 034
 Notes: (1) When set to 000, the Julian date is automatically calculated; otherwise, the Julian date will print
as that entered number, without daily increments. If factory defaults are restored the actual Julian
date will also be restored.
(2) Printers without the Real Time Clock option lose the set time/date when power is removed.
(3) Response format is variable; see the Special Label Formatting Command <STX>T.