Datamax-O'Neil Class Series Programmer’s Manual - Manual (Page 87)

Extended System-Level Command Functions
Class Series Programmer’s Manual 73
(NT) Network Setup – This command configures the printer for an Ethernet connection. Each
octet must be zero-filled to be properly interpreted (e.g., an IP Address of 10.12.0.243 must be
sent to the printer as 010.012.000.243).
Value Parameter Interpretation Default Value *
D a
Is Discovery (DHCP or Bootp), where a:
Y = Enable
N = Disable Y
G yyy.yyy.yyy.yyy
Is the Gateway Address, where:
y = 0 to 9
000.000.000.000
I xxx.xxx.xxx.xxx
Is the IP Address, where:
x = 0 to 9
192.168.010.026
N xxx.xxx.xxx.xxx
Is the SNMP Trap Address, where:
x = 0 to 9
000.000.000.000
P xxxx
Is the Port number, where:
x = 0 to 9
9100
S yyy.yyy.yyy.yyy
Is the Subnet Mask, where:
y = 0 to 9
255.255.255.000
T a
Is SNMP enable,
where a:
Y = Enable
N = Disable
Y
U xxx.xxx.xxx.xxx
Is the WINS2 Address, where:
x = 0 to 9
000.000.000.000
w a
Is WiFi enable, where a:
Y = Enable
N = Disable N
W xxx.xxx.xxx.xxx
Is the WINS1 Address, where:
x = 0 to 9
000.000.000.000
Y xxx.xxx.xxx.xxx
Is the DNS1 Address, where:
x = 0 to 9
000.000.000.000
Z xxx.xxx.xxx.xxx
Is the DNS2 Address, where:
x = 0 to 9
000.000.000.000
* Prior to the introduction of WiFi , 192.0.0.192 was the IP default value and the Subnet Mask was 0.0.0.0.
Table 5-5: Network Setup