Burkert Type 8793 - Manual (Page 217)

217
DeviceNet
33. START-UP DEVICENET
33.1. Safety instructions
WARNING!
Risk.of.injury.from.improper.operation!
Improper operation may result in injuries as well as damage to the device and the area around it
• Before start-up, ensure that the operating personnel are familiar with and completely understand the contents
of the operating instructions.
• Observe the safety instructions and intended use.
• Only adequately trained personnel may start up the equipment/the device.
Before start-up, carry out fluid installation (see Chapter “13”) and electrical installation (Chapter “32”) of
Type 8792/8793 and of the valve.
33.2. Start-up sequence
The following basic settings are required for start-up of the DeviceNet version of Type 8792/8793:
Device.type Sequence Type.of.basic.setting Setting.via Description.
in.chapter
8792 and 8793 1 Adjust device to the local conditions X.TUNE “23.2”
For.8793.only
(Process
control)
2 Activate process controller. ADD.FUNCTION “24”
8792 und 8793
Settings on Type 8792/8793:
BUS.COMM “33.3”
3 Input device address.
4 Select baud rate.
5 Activate or deactivate safety position.
Configuration:
The process data is transferred via an
I/O connection.
DeviceNet Master
by means of ESD
file and special
software
“33.4”
5 Initialize the I/O connection to transfer the
– Static Input Assemblies
– Static Output Assemblies.
Table 117: Start-up sequence for DeviceNet
english
Type 8792, 8793