Edit block parms – CONTREX CX-1200 User Manual
Page 165
5 - 72
EDIT BLOCK PARMS
0
*
0
*
0
*
0
*
P2/4
->NOT USED
Block Parm 5
Block Parm 6
Block Parm 7
Block Parm 8
->NOT USED
->NOT USED
->NOT USED
EDIT BLOCK PARMS
0
*
0
*
0
*
0
*
P4/4
->NOT USED
Block Parm
13
Block Parm 14
Block Parm 15
Block Parm 16
->NOT USED
->NOT USED
->NOT USED
EDIT BLOCK PARMS
0
*
0
*
0
*
0
*
P3/4
->NOT USED
Block Parm
9
Block Parm 10
Block Parm 11
Block Parm 12
->NOT USED
->NOT USED
->NOT USED
Use the Par keys to select a
line (make it active).
Displays the name of the
Control Parameter that you
assigned to the line above.
This assignment will also
be reflected in the Edit
Block screens (0-7).
(CP-512)
Enter a parameter code.
Press the Enter key.
Use the Page keys to scroll through pages 2 through 4 of the Edit Block Parms screens. These
screens are similar to each other and to the page one screen that is displayed on the previous page.
Enter Control Parameter codes in these screens, as noted below.
If you enter a Control Parameter code that is already in use, then the “Not Allowed“ messages will
flash briefly in the error message bar. If you enter a code that does not exist, the “Not Used”
designation (or Parameter Name if the line is in use) beneath the Block Parm line will change to
“Not Defined”. However, if you enter a code that does not exist and the code number is higher than
“350“, then the error message “Max Error” will flash briefly in the error message bar.
If you accidently enter too many digits for a code (e.g., 1022), the error message “Field Full” will
flash briefly.