CONTREX CX-1200 - Manual (Page 99)

5 - 6
STATUS SCREEN SETUP P1/1
You can customize the six status lines, as well as the large number display and the E.U. line on the Status
screen. To customize the large number display, enter this code of the parameter that you want displayed in
Lg Number Parm (CP-440). Use Large Number Units (CP-449) to select and customize the E.U. line that
appears immediately below the large number display. For each of the status lines (CP-441 through
CP-446), enter the code of the parameter that you want to appear on the corresponding line. You can enter a
“0” in status lines 2 - 6 if you want them to remain blank. You can also access and change Control Parameters
441 through 446 while you are in the Status screen by using the Code key. For details on the Code key, refer
to the Status screen in Operator Interface: Screen Operation.
Lg Number Parm
Use Large Number Parameter (CP-440) to select the parameter that displays in the Large Number Display in the Status
screen (refer to the status screen in Operator Interface: Screen Operation. You can also use the Code key to access
and change CP-440 in the Status Screen.
Lg Number Units
Use Large Number Units (CP-449) to select the E.U. text that displays immediately below the Large Number
Display in the Status screen (refer to the status screen in Operator Interface: Screen Operation). Enter the numeric
code that identifies the E.U. for the Control Parameter displayed in the Large Number Parameter (CP-440). Refer
to CP-449 in Appendices: Appendix C for the numeric code list. The Help screen for CP-449 also contains a partial
list of numeric code options. In addition, you can also scroll through the numeric code options by accessing CP-449
with the Code key while you are in the in the Status screen.
Status Line 1
Use Status Line 1 (CP-441) to select the parameter that displays on the first line, under the Large Number Display, of the
Status screen (refer to the status screen in Operator Interface: Screen Operation). You can also use the Code key to
access and change CP-441 in the Status screen.
Status Line 2
Use Status Line 2 (CP-442) to select the parameter that displays on the second line (under the Large Number Display)
of the Status screen (refer to the status screen in Operator Interface: Screen Operation). If you want this line to
remain blank, enter a “0” in CP-442. You can also use the Code key to access and change CP-442 in the Status screen.
Status Line 3
Use Status Line 3 (CP-443) to select the parameter that displays on the third line (under the Large Number Display) of
the Status screen (refer to the status screen in Operator Interface: Screen Operation). If you want this line to remain
blank, enter a “0” in CP-443. You can also use the Code key to access and change CP-443 in the Status screen.
Status Line 4
Use Status Line 4 (CP-444) to select the parameter that displays on the fourth line (under the Large Number Display) of
the Status screen (refer to the status screen in Operator Interface: Screen Operation). If you want this line to remain
blank, enter a “0” in CP-444. You can also use the “Code key to access and change CP-444 in the Status screen.
Status Line 5
Use Status Line 5 (CP-445) to select the parameter that displays on the fifth line (under the Large Number Display) of
the Status screen (refer to the status screen in Operator Interface: Screen Operation). If you want this line to remain
blank, enter a “0” in CP-445. You can also use the “Code key to access and change CP-445 in the Status screen.
Status Line 6
Use Status Line 6 (CP-446) to select the parameter that displays sixth line (under the Large Number Display) of the
Status screen (refer to the status screen in Operator Interface: Screen Operation). If you want this line to remain
blank, enter a “0” in CP-446. You can also use the “Code key to access and change CP-446 in the Status screen.