CONTREX CX-1200 - Manual (Page 193)

5 - 100
PLC MONITOR P2/4
PLC 23-16
PLC 23-16 (MP-111) displays the status of the internal PLC status bits 23-16. A “1” in any bit indicates that the bit is
“active”. Page one of the “Help” screen displays the bit map for PLC 23-16. Also refer to Appendices: Appendic C.
PLC 31-24
PLC 31-24 (MP-112) displays the status of the internal PLC status bits 31-24. A “1” in any bit indicates that the bit is
“active”. Page one of the “Help” screen displays the bit map for PLC 31-24. Also refer to Appendices: Appendic C.
PLC 39-32
PLC 39-32 (MP-113) displays the status of the internal PLC status bits 39-32. A “1” in any bit indicates that the bit is
“active”. Page one of the “Help” screen displays the bit map for PLC 39-32. Also refer to Appendices: Appendic C.
PLC 47-40
PLC 47-40 (MP-114) displays the status of the internal PLC status bits 47-40. A “1” in any bit indicates that the bit is
“active”. Page one of the “Help” screen displays the bit map for PLC 47-40. Also refer to Appendices: Appendic C.
PLC 55-48
PLC 55-48 (MP-115) displays the status of the internal PLC status bits 55-48. A “1” in any bit indicates that the bit is
“active”. Page one of the “Help” screen displays the bit map for PLC 55-48. Also refer to Appendices: Appendic C.
PLC 63-56
PLC 63-56 (MP-116) displays the status of the internal PLC status bits 63-56. A “1” in any bit indicates that the bit is
“active”. Page one of the “Help” screen displays the bit map for PLC 63-56. Also refer to Appendices: Appendic C.
PLC 71-64
PLC 71-64 (MP-117) displays the status of the internal PLC status bits 71-64. A “1” in any bit indicates that the bit is
“active”. Page one of the “Help” screen displays the bit map for PLC 71-64. Also refer to Appendices: Appendic C.
PLC 79-72
PLC 79-72 (MP-118) displays the status of the internal PLC status bits 79-72. A “1” in any bit indicates that the bit is
“active”. These bits are only used to monitor the operating state of the CX-1102. Page one of the “Help” screen
displays the bit map for PLC 79-72. Also refer to Appendices: Appendic C
PLC 87-80
PLC 87-80 (MP-119) displays the status of the internal PLC status bits 87-80. A “1” in any bit indicates that the bit is
“active”. These bits are only used to monitor the parameter block that is active. Page one of the “Help” screen displays
the bit map for PLC 87-80. Also refer to Appendices: Appendic C.
PLC 95-88
PLC 95-88 (MP-120) displays the status of the internal PLC status bits 95-88. A “1” in any bit indicates that the bit is
“active”. Page one of the “Help” screen displays the bit map for PLC 95-88. Also refer to Appendices: Appendic C.