CONTREX CX-1200 - Manual (Page 80)

4 - 5
Step 1 - Freq In 2 & CO Setup - Parameter Entry
The CX-1200 will display System Setup Freq In\Page 1.
Configure the CP’s on this screen as required.
State {MP-50}
Cnt Mode FI2 {CP-265}
PPR FI2 {CP-266}
CO Mode {CP-270}
CO Max Volts {CP-271}
NOTE: The Help key accesses the Help screen and gives you a brief description of the parameter or subject
that is highlighted (active) on the screen. Press the Help key again to return to the previous screen.
Press the "Page Down" key to proceed to the next page.
Step 2 - Motor/Encoder Signal Polarity Setup - Parameter Entry
The CX-1200 will display System Setup Signal Polarity\Page 2.
Configure the CP’s on this screen as required.
State {MP-50}
RUN Mode {CP-202}
Direct SPx {CP-201}
CO Polarity {CP-272}
CO Offset {CP-273}
CO Volts {MP-37}
FI2 Hz {MP-03}
NOTE: The Help key accesses the Help screen and gives you a brief description of the parameter or subject
that is highlighted (active) on the screen. Press the Help key again to return to the previous screen.