CONTREX CX-1200 - Manual (Page 469)

H - 1
Error Definition
(Continued)
Acl Tm High Acceleration time is too high.
Acl too Hi Acceleration rate is too high.
Adrs Error Address Error, there is an internal address conflict with the CPU.
Bad Blk Calc During calculations for one of the parameter blocks, an error was
encountered causing the block to be marked as bad. The block
parameter value(s) in error should be corrected.
Bad Blk Sel An attempt was made to switch to a bad parameter block.
Binary Only The number is Binary, only “1’s” and “0’s” may be entered.
BkUp Loaded Prompt which displays on completion of loading a code parameter
backup into main CP list.
Blk Parm Err An error was encountered in the block parameters.
Blk Val Err An error was encountered in the block values of a block.
Buss Error There is an internal buss conflict with the CPU.
ChkSm Error Checksum Error, the checksum calculated for memory data is not
correct.
Dcl Tm High Deceleration time is too high.
Default Set Prompt after resetting a parameter back to its default value.
Defaults Set Prompt after resetting all parameters back to their default values.
Divide By 0 Math error has occurred internal resulting in divide by zero.
DP Present Decimal point already present in the number you are entering.
Dspl Error Display Error, an error has occurred when attempting to display a
parameter (e.g., the parameter does not exist).
Field Full The maximum number of characters (digits, decimal point, negative
sign) allowed for parameter entry has been reached while entering a
number via the keypad. You tried to enter more numbers/characters
than will fit into the space allotted for the parameter value entry.
Flts Cleared Prompt to indicate that the faults have been cleared, as a result of
entering a 1 into Clr Fault Cntrs (CP-491)
Gen Intrpt Some error occurred during the controls program execution to cause
a General Interrupt.
APPENDIX H: ERROR CODE DEFINITIONS