Luminex xPONENT 4.2 for FLEXMAP - Manual (Page 103)

Use this tab to select or edit analytes used in the batch or protocol. This tab contains the
following:
This tab contains the following:
• Analytes grid - A grid representing each analyte from 1 to 500. Select All selects all
analytes, and Deselect All deselects all analytes. Click a numbered analyte to select it;
click the analyte again to deselect it. You can also click and drag to select groups of
analytes. Selected analytes are red. Deselected analytes are gray. An analyte marked as
an intra-well normalization bead is blue.
• Default Analysis - The default analysis changes based on the Analysis Type selected in
the Settings tab. You can change the analysis settings for all analytes by clicking Change
if this button is enabled in this tab. This displays the Analysis Settings dialog box.
• If you selected Quantitative on the Settings tab, the default analysis formula is 5P
Weighted.
• If you selected Qualitative on the Settings tab, the default analysis is Luminex
Qualitative. Change the default value by selecting either Luminex Qualitative or No
Analysis.
• If you selected Allele Call on the Settings tab, the default analysis, Luminex Allele
Call. Change the default value by selecting Luminex Allele Call.
• Click Apply to All Analytes to apply your selection to all selected analytes. Click OK to
change the default analysis to the analysis you selected. Click Cancel to close the
dialog box without saving.
• Units - Type the desired units for the analytes in this box.
• Count - Type the desired bead count for the analytes by clicking in the Count box. If each
selected bead set does not acquire this number of events, a warning is added to the log
that not enough bead events were acquired. If you select bead sets that are not present,
the analyzer continues to acquire, trying to reach the number of events per bead for bead
Protocols Page
89