Luminex xPONENT 4.2 for FLEXMAP - Manual (Page 54)

Default Analysis - The default analysis changes based on the Analysis Type selected in the
Settings tab. You can change the analysis settings for all analytes by clicking Change if this
button is enabled in this tab. This displays the Analysis Settings dialog box.
FIGURE 1. Analysis Settings Dialog Box
If you selected Quantitative on the Settings tab, the default analysis formula is 5P Weighted.
To change the default, select one of the following from the Method list:
• No Analysis
• Cubic Spline
• Linear Fit
• Logistic 4P
• Logistic 5P
If you selected Logistic 4P or Logistic 5P, select a weight type of either None or 1/y2.
If you selected Qualitative on the Settings tab, the default analysis is Luminex Qualitative.
Change the default value by selecting either Luminex Qualitative or No Analysis.
Click Apply to All Analytes to apply your selection to all selected analytes. Click OK to
change the default analysis to the analysis you selected. Click Cancel to close the dialog box
without saving. For more information, see the “Analysis Settings” section.
Units - Type the desired units for the analytes in this box.
Count - Type the desired bead count for the analytes by clicking in the Count box. If each
selected bead set does not acquire this number of events, a warning is added to the log that
not enough bead events were acquired. If you select bead sets that are not present, the
analyzer continues to acquire, trying to reach the number of events per bead for bead sets
that are not in the sample. Therefore, choose only the bead sets present in your sample.
Apply All - Applies the information in the Units and Counts boxes to all analytes.
Total Count - Select Stop after bead count reaches: to stop acquisition when the bead count
reaches a certain number determined by the user. Type the desired value in the box. The
default value is 100.
You can also specify the minimum allowable bead count per well that the xPONENT ®
software analyzes. This excludes data from any beads carried over during acquisition.
xPONENT ® for FLEXMAP 3D ®
40