Luminex xPONENT 4.2 for FLEXMAP - Manual (Page 105)

• Units - The unit of measurement you specified in the Unit box. Click this box to type a
value for the analyte.
• Count - Type the desired bead count for the analytes by clicking in the Count box. If
each selected bead set does not acquire this number of events, a warning is added to
the log that not enough bead events were acquired.
• Region - Refers to the specific analyte selected. This is a number between 12 and 78.
• Group - If you have selected Allele Call from the Analysis Type in the Settings tab, this
button is displayed. Click Group to group 2, 3, or 4 analytes for the group. Multiple groups
can be defined.
• Cancel - Click Cancel to return to the Batches tab.
• Back - Click Back to return to the Settings tab.
• Next - Click to go to the next tab.
NOTE: If the Analysis Type selected in the Settings tab was None or
Allele, this takes you to the Plate Layout tab. If the Analysis Type
selected was Quantitative or Qualitative, this button takes you to
the Stds & Ctrls tab.
Standards and Controls (Stds & Ctrls) Tab
Protocols > Stds & Ctrls
Use this tab to delete, edit, export, import, and create standards and controls.
This tab contains the following:
• Create New Std/Ctrl Lots - Opens the Select Protocol box.
Protocols Page
91