IAI America IA-101-X-USBMW - Manual (Page 230)

15. T
ool
222
If this checkbox is not selected, symbol errors will not
be checked.
If this checkbox is not selected, the communication port
which can be used will not be checked.
However, selectable communication ports are extended
to COM1 to COM256 in the communication check
window.
If the selected communication port cannot be used, the
"EC5: communication port open error" will occur.
If this checkbox is not selected, partial correction will be
possible when the ‘Cmnd’ column is double-clicked.
Specify the default parameter transfer option.
If this checkbox is selected, symbols will be
shown in the variable window, I/O window, flag
monitor window and position data edit window.
Position data editing is permitted for four axes in
the case of X-SEL J/K controllers, and six axes
in the case of the P/Q and PX/QX controllers.
In the case of the R/S, RX/SX or RXD/SXD type,
editing of position data for eight axes is
permitted.
This function is not supported by the X-SEL-J/K,
JX/KX, TT, XSEL-P/Q (application version 0.01 -
0.35) or X-SEL-PX/QX controller (application
version 0.01 - 0.16).
15. Tool
The Environment Setup window accessible from the Tool menu consists of the Setting and Timer tabs.
(1) Setting
Specify whether or not to check symbols during the program error check.
Fig. 16.1 Setting (Offline)
Fig. 16.2 Setting (Online)