IAI America IA-101-X-USBMW - Manual (Page 54)

1. Before
You Begin
46
[4] If XSEL-P/Q (application version 0.36 or later), XSEL-PX/QX (application version 0.17 or later), XSEL-R/S,
XSEL-RX/SX, XSEL-RXD/SXD, SSEL, ASEL, or PSEL (application version 0.01 or later) is connected,
the Two or more programs start permission/prohibition setting screen (Fig. 1.48) will be displayed. Set
whether you prohibit or permit the simultaneous starting of multiple programs during the manual mode,
and click the OK button.
[Two or more programs start prohibition (MANU)]
It prohibits the simultaneous starting of multiple programs during the manual mode.
[Two or more programs start permission (MANU)]
It permits the simultaneous starting of multiple programs during the manual mode.
Fig. 1.48 Two or More Programs Start Permission/Prohibition Setting Screen
If Don’t Show this window from next time on is checked, connection will be established with the settings at the
last connection time without displaying the screen in Fig. 1.48.
To remove this check, select the checkbox In Connect, Check Setting of Two or more programs start on the
Environment Setup (Online) screen (Fig. 16.2) or Environment Setup (Offline) screen (Fig. 16.1). The screen
in Fig. 1.48 will be displayed at the next startup time to remove the check.
For the Environment Setup (Online) screen and Environment Setup (Offline) screen, refer to "16. Tool."
If you set Two or more programs start prohibition (MANU) when multiple programs have already started, the
warning message will be displayed. To prohibit the simultaneous starting of multiple programs, click the Yes
button to stop all the programs.
Fig. 1.49 Warning Message
[5] Once the controller connection is confirmed, the application will start in the offline mode. If the controller
cannot be recognized or the CANCEL button is clicked in this window, the application will start in the
offline mode. (Even after the application has started in the offline mode, you can use the "Reconnect"
function explained later to switch the application to the online mode.)
If Don’t Show this window from next time on is selected, the software will automatically select the port
name and baud rate that were in use the last time the application was closed and check the controller
connection based on these settings.