Anritsu 681XXC - Manual (Page 118)

Configuring
the GPIB The GPIB configuration menus let you perform the
following:
q Set the GPIB address and select the GPIB line
terminator for the signal generator.
q Turn on the source lock mode for operation
with a Model 360B Vector Network Analyzer.
q Select the model and set the GPIB address for
the power meter used to create a user level
flatness correction power-offset table.
q Select the external interface language for re-
mote operation of units with Option 19.
q Select scalar mode of operation with a Hewlett
Packard Model 8757D Scalar Network Ana-
lyzer.
To go to the Configure GPIB menu from the System
Configuration menu, press
GPIB . The Configure
GPIB Menu (below) is displayed.
Press GPIB Address to change the address of the
681XXC on the bus (the signal generator’s default
GPIB address is 5). Enter a new address, between 1
and 30, using the cursor control key or the data en-
try keypad and the terminator key
Hz
ns
ADRS
The new GPIB address will appear on the display.
Press Line Term to select a carriage return ( CR ) or
a carriage return and line feed ( CR/LF ) as the GPIB
data delimiter. Consult the GPIB controller’s man-
ual to determine which data delimiter is required.
681XXC OM 3-85
LOCAL (FRONT SYSTEM
PANEL) OPERATION CONFIGURATION