Anritsu 681XXC - Manual (Page 55)

Selecting a
CW
Frequency There are several ways to select a CW frequency for
output. You can (1) edit the current frequency, (2)
enter a new frequency, or (3) select one of the 20 pre-
set frequency parameters.
Editing the Current Frequency
Press
Edit F1 to open the frequency parameter,
then edit the current CW frequency using the cursor
control key or the rotary data knob. To close the
open frequency parameter, press
Edit F1 or make
another menu selection.
Entering a New Frequency
Press
Edit F1 to open the frequency parameter,
then enter the new CW frequency using the keypad
and appropriate terminator key. To close the open
frequency parameter, press
Edit F1 or make an-
other menu selection.
Selecting a Preset Frequency
To select one of the preset frequencies for output,
press the main menu key
FREQUENCY
CONTROL
The CW Frequency Control Menu (below) is dis-
played.
This menu lets youperform the following:
q Select preset frequencies F0 , F1 , F2 , M1 , or M2
for output.
q Go to the frequency list menu (to tag, edit,or
output a frequency from the list).
q Go to the tagged frequencies menu (select a
tagged frequency for output).
3-22 681XXC OM
LOCAL (FRONT CW FREQUENCY
PANEL) OPERATION OPERATION