HT instruments SIRIUS89N - Manual (Page 13)

SIRIUS89N
EN - 11
5. INITIAL SETTINGS
By pressing the
MENU key the following screen will be displayed:
MENU GENERAL
SAFETY TEST MEMORY
ANALYZER MEMORY
RESET
ANALYZER CONFIG
RECORDER CONFIG
CONTRAST
DATE&TIME
LANGUAGE
↓ ↑
It’s not possible to enter the
MENU during a recording or a Real Time Energy
measurement. Pressing this button during a recording the display will show main recording
parameter (see paragraph 10.3).
5.1.
HOW TO ADJUST THE CONTRAST
By pressing the multifunction keys F1 and F2, position the cursor on the CONTRAST item
and confirm it by pressing the ENTER key.
By pressing the multifunction keys
F3 and F4, adjust the contrast (higher values
correspond to a higher contrast while lower values correspond to a lower contrast) and
press the
ENTER key to SAVE the change or press ESC to quit the modification.
This setting will remain unchanged after turning off the instrument.
5.2.
HOW TO SET DATE AND TIME
By pressing the multifunction keys
F1 and F2, position the cursor on the DATE&TIME item
and confirm it by pressing the ENTER key.
The time is expressed as
hh:mm (2 digit for hours, 2 digit for minutes) military time.
Press the ENTER key to SAVE the change or press ESC to quit the modification.
This setting will remain unchanged also after turning off the instrument.
5.3.
HOW TO SET THE LANGUAGE
By pressing the multifunction keys
F1 and F2, position the cursor on the LANGUAGE (EN)
or
LINGUA (IT) item and confirm it by pressing the ENTER key.
By pressing the multifunction keys
F1 and F2, position the cursor on the desired language
and press the
ENTER key to SAVE the change or press ESC to quit the modification.
This setting will remain unchanged after turning off the instrument.