HT instruments SIRIUS89N - Manual (Page 130)

SIRIUS89N
EN - 128
17. APPENDIX 1 – MESSAGES DISPLAYED
Message Description Advices
AUTONOM: Available memory autonomy for the recording which is
being effected
CLEAR ALL? (Enter) The operator is trying to cancel all the recordings effected Press ESC in order not to cancel the whole
memory, press ENTER to confirm
CLEAR LAST? (Enter) The operator is trying to cancel the last recording effected Press ESC in order not to cancel the last
recording, press ENTER to confirm
Data saved The data have been saved
DATA SIZE: Dimensions of the stored data
HOLD By pressing the proper key, the HOLD function has been
activated
Press HOLD again to disable this function
Password: A recording has been started and at least 5 minutes have
passed from the last activity of the instrument (see
paragraph 7).
Insert the password:
F1, F4, F3, F2
Invalid date The inserted date is not correct Check the inserted date
Energy Measuring The instrument is taking an energy measurement Press F1 to stop it
Memory Full The memory of the instrument is full Cancel some recordings after transferring
them to a PC
No ext supply! A recording has been started without connecting the
external power supply (optional code A0050)
Verify it you really want to start the recording
without the external power supply. In that
case press START again.
No parameter sel A recording has been started without selecting any value to
be recorded
Press START/STOP and select at least a
value entering the MENU
No Phase selected Voltage and/or current harmonics have been selected and
the corresponding flag has been enabled (HARMONICS
ON) but no phase voltage or current has been selected
Select at least one phase voltage and/or
current
PASSWORD ERROR The inserted password is wrong (see paragraph 7). Check the password
PASSWORD OK The inserted password is correct
Please wait The instrument is waiting for the recording to be started
(see paragraph 6)
Recording The instrument is recording (see paragraph 6)
Too many param More than 63 parameters have been selected (harmonics
included) or More than 38 parameters with CO-
GENERATION Flag enabled
Deselect some values
Too many records The quantity of recorded data + Smp exceeds the
maximum allowed (35)
Cancel some recordings after transferring
them to a PC
No Unit selected
ERR: SEQ The Phase Sequence isn’t correct. Check the Phase Sequence connection.
ERR: P- The active powers shown on the right side of the message
are negative If there isn’t a situation of co-generation
check if the clamps are properly connected
ERR: SEQ & P- The active powers shown on the right side of the message
are negative and the Phase Sequence isn’t correct.
If there isn’t a situation of co-generation
check if the clamps are properly connected /
check the Phase Sequence connection.
ERR: CONNECTION The instrument has detected a wrong connection to
Voltage inputs
Check the Voltage connections
Error Vref The user set a Voltage reference not compatible with
voltage at instrument’s input.
Check Voltage Reference set in “CONFIG
RECORDER”
ERR: SYNC The System Frequency is out of range Check the System Frequency, check setting
in ANALYZER CONFIG.
Selection Error There is a mismatch between the Parameter enabled and
the parameter selected for an AUX recording.
Check the parameter enabled in AUX
position and the selected parameter for
recording.
Error1 ÷ Error 5 The instrument memory is damaged. Contact HT Italia assistance