HT instruments SIRIUS89N - Manual (Page 68)

SIRIUS89N
EN - 66
8.2. BASIC SETTING: RECORDER CONFIG
Place the rotary switch in the
ANALYZER position, press the MENU key, using the F1/F2
keys select the
RECORDER CONFIG item and press the ENTER Key.
This option allows you to check and eventually modify the recording parameters and the
selected parameters (up to a maximum of 62+Frequency). If the number of selected
values exceeds 63 the message "
too many param " will be displayed. The RECORDER
CONFIG mode is divided into 4 separate sub-pages:
1
st
page: This page allows you to set the START/ STOP mode (AUTO or MANUAL),
the START and STOP time if AUTO mode is selected, the Integration
Period value, the Enabling/Disabling of Voltage Anomalies detection, the
Enabling/Disabling of Harmonics detection. Press
ENTER to confirm the
settings and pass to the following page.
Press
ESC to leave the Menu without modifying the existing parameters.
2
nd
page: This page is devoted to the settings relevant to the
VOLTAGE recording.
Press
ENTER to confirm the settings and pass to the following page.
Press ESC to leave this page without modifying the existing parameters.
From this page you can enter the sub-page “Harmonics” which permits to
select the voltage harmonics to be recorded.
Press
ENTER to confirm the settings and leave the “Menu Harmonics".
Press
ESC to leave the "Menu Harmonics" without modifying the existing
parameters.
3
rd
page: This page is devoted to the settings relevant to the
CURRENT recording.
Press
ENTER to confirm the settings and pass to the following page.
Press
ESC to leave this page without modifying the existing parameters.
From this page you can enter the sub-page “Harmonics” which permits to
select the current harmonics to be recorded.
Press
ENTER to confirm the settings and leave the “Menu Harmonics".
Press ESC to leave the "Menu Harmonics" without modifying the existing
parameters.
4
th
page: Menu composed of two sub-pages devoted to the selection of the
POWERS and ENERGIES to be recorded. From this page you can enter
the sub-page “POWER” and “ENERGY” which permits to select the
parameters to be recorded.
Selecting the active powers for the recording, the corresponding active
energies will be automatically selected.
Selecting the reactive powers for the recording, the corresponding reactive
energies will be selected.
Press
ENTER to leave this page confirming the modifications made.
Press
ESC to leave the "Menu" without modifying the existing parameters.
The various pages of the " RECORDER CONFIG" can be schematised as follows: