HT instruments SIRIUS89N - Manual (Page 85)

SIRIUS89N
EN - 83
8.6.3. "WAVE" mode
Selecting the WAVE mode the screen below will be displayed according to the settings
made as per paragraph 8.1. The screen shows the waveform of the current and the
voltage.
Example of screen
The symbols used are described in Tab. 3.
For eventual messages displayed see appendix 1 – MESSAGES DISPLAYED.
Following keys are enabled:
ESC:
to return back to METER mode (see paragraph 8.6.2).
SAVE: to save in the instrument memory a record of “Smp” type (see
paragraph 9.2) containing the instantaneous values of voltage and
current present on the instrument inputs. This function is disabled
during a recording.
ENTER/HOLD: to enable/disable the HOLD function (updating interruption) of the
displayed data. All the previous functions remain however available.
When the HOLD function is enabled, the word
HOLD is displayed.
When this function is enabled it’s not possible to record or take an
energy measurement. This function is disabled during a recording or
an energy measurement.
MENU:
to enter in the
MENU mode and change the instrument settings (see
paragraph 8.1 and 8.2). It’s not possible to enter the configuration
MENU during a recording or an energy measurement.
START/STOP: to
record
selected parameters according to the instrument’s settings
(see chapter 10).
27.09.00 17:35:12
V1 = 229.7 V
I1 = 132.0 A
Pf1 = 0.98 i