Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 101)

Remote Infrastructure Management System - Version 1.0 / July 2014
Chatsworth Products, Inc. (CPI) • 800-834-4969 101
Table 3.27 Modbus/SNMP/BACnet Slave Configuration Options
Option Description
SNMP Community
Assign a community name to provide an added layer of security, and control
access to the SNMP device.
Description Enter a description for the Slave device.
Pager Alarms
(Requires Modem)
Enter the Phone Number Configuration Entry ID for up to five pager numbers to
which the RIM-1000 will send notification when any alarm for this Slave occurs.
The Entry ID numbers correspond to phone numbers configured from the Configure
Phone Number links at the bottom of the Modem Configuration page. Separate
the ID numbers with commas. Enter zero to disable. The RIM-1000 will dial the
lowest number listed regardless of the order the numbers are listed.
Example: If the Alarm dial out string is set to “3, 5, 1, 0, 0,” the RIM-1000 will dial
Pager #1, Pager #3 and then Pager #5 when an alarm occurs.
Summary Relay
When any alarm is activated on the Modbus device, a designated
relay can be tripped.
Map Coordinate
Adjust the numbers in the X and Y coordinate boxes to fine tune the location of
this Slave unit on the RIM-1000’s graphical map.
If you edit the values in the boxes, be sure to click the Submit Changes button at
the top of the screen to save the new information
If coordinates do not appear in these boxes, then the Slave unit has not yet been
added to the RIM-1000’s graphical map.
Graphical Mapping
To add the Slave device to the RIM-1000’s graphical map, click the Graphical
Mapping link. A blue dot that represents this slave unit will appear on the upper
left corner of the screen. Drag and drop the blue dot into the appropriate position.
Click the Submit Changes link at the bottom of the map to save the unit’s location.
If you have further questions regarding Mapping, refer to 3.4.26, “Map (Facility
Mapping)” on page 109.
Test Map Click this link to view the mapped location of this Slave unit.
Email Recipient
Notification
Check the recipient email addresses that require notification when any alarm
occurs on this Slave. Email addresses are displayed once they are entered on the
Email Configuration page.
Preset Register
Button
You can configure a button that will appear on this device’s display page. The
button will reset a specific register when it’s clicked. This functionality is intended
to be used for data that starts at a set point and continues to increase - like KWH
- and not data that is a single readable value, like a temperature or humidity
reading.
Register This is the register number that will be reset when the button is pushed.
Data This is the value that the register should be reset to.
Preset Register
Button Text
Type the text that will appear on the button on the web page.